Explanations · 7 min
What load flexibility is and how to prove it
Load flexibility is a device's ability to change its consumption or output briefly on request and then return. What counts is not the promise but the measured response.
Flexibility in plain words
The power system must balance generation and consumption every moment. Traditionally power plants did that. Now consumers can take part: delay a water heater for a few minutes, pause charging, discharge a home battery. This is called demand-side flexibility or demand response.
One water heater gives little. But thousands of devices pooled by an aggregator behave like a small power plant. For an aggregator to rely on them, each device must respond predictably and prove it with measurements.
Which devices can be flexible
| Device | What flexibility it gives |
|---|---|
| Battery (BESS) | Charge and discharge both ways within its power and state of charge (SOC). |
| Electric water heater | Delay or shift heating while there is thermal reserve. It never returns energy to the grid. |
| Other controllable load | Temporarily reduce consumption to a declared floor and return to baseline. |
Flexibility must never bypass protection: the thermostat, thermal cut-out, BMS and electrical protection always take priority over an external command.
Baseline: what to measure against
A response can only be judged against what the device would have done without the command. For a load the Lab captures a measured baseline before the command. For example: baseline -5 kW, a command to curtail to -3 kW, so the flexibility is 2 kW. After the command the load must return to the measured baseline, not to zero.
A water heater can only curtail while its element is actually heating. If the water is already hot and the element is off, there is no flexibility at that moment, even though the device is online.
Why an acknowledgement is not proof
A device can reply “accepted” and do nothing. So the Lab records each stage separately:
| Signal | What it proves |
|---|---|
| ACKNOWLEDGED | The command was received. |
| EXECUTED | The device says it applied the setpoint. |
| MEASURED | An independent measurement shows the new power. |
| RESTORED | After the lifetime the measurement shows a return to baseline. |
- CommandThe Lab sends a power, a duration and a TTL within the profile's limits.
- AcknowledgedThe connector accepted the command.
- ExecutedThe device applied the new power.
- MeasuredAn independent measurement sees the change.
- RestoredAfter the duration the device returns to its baseline.
Each stage is separate evidence with its own source. An acknowledgement does not yet mean the power changed.
How to check flexibility in Wesfin Lab
Describe the device with a profile
Power limits, baseline, minimum on and off times, a stale-data policy.
Run the standard tests on the simulator
Deterministic scenarios check limits, command lifetime, lost connections and restoration.
Connect a source in observe-only mode
Over MQTT or Home Assistant. Writes need separate local consent and fresh telemetry.
Send a bounded command
A small change for a few seconds with a TTL, after which the device returns to baseline on its own.
A Lab report is not a certification and gives no right to take part in an energy market. Wesfin holds an aggregator licence in Ukraine, but Wesfin Flex commercial services have not launched.